RADVision SCOPIA 1000 Guía de usuario descargar pdf (Pagina 53)

'Initial Configuration' | 47

RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0

Step 5 If a gatekeeper is not present in the network, report the IP number of the gateway. If a gatekeeper

is present, this number is not needed.

Note: In Solution mode (when a gatekeeper and iVIEW are available), the Codec Unit must be

registered with the gatekeeper.

Step 6 After this setup, the user can easily place an ISDN call (as explained in the User Guide).

Figure 2-10 Basic Call

If the user wants to change the Rate of the call, he may use the Advanced Options page in the

Direct Call GUI, and select the pre-defined rate. When the SCOPIA gateway is used, the Codec

Unit will automatically detect the rate used to place the call.

Figure 2-11 Advanced Call

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 78 79

SCOPIA XT1000 1
Chapter '' 2
Table of Contents 3
Table of Contents 4
3 Maintenance Tasks 5
4 Troubleshooting 5
Table of Contents 6
Architecture Considerations 7
Firewall/NAT Support 10
ISDN Connectivity 11
Implementing External Control 11
Initial Configuration 13
Enabling the Software License 14
Figure 2-4 Web Access 16
Figure 2-5 Web Interface 16
Step 6 Press Enable license 17
Procedure 21
Step 3 Press Next 21
Setting Date and Time 22
Network Settings 23
Setting System Preferences 24
Setting the Time Zone 25
Setting Regional Data 26
Configuring Video Connections 28
Configuring the Monitor 30
Configuring Audio Connections 33
Configuring the EchoCanceller 35
Configuring Audio Outputs 36
Settings for HDMI Recording 36
Configuring Network Settings 38
Step 2 Scroll to Preferences 39
Step 5 Press Save 43
Configuring Bandwidths 45
Configuring Gatekeeper Use 47
Configuring Gateway Use 49
Configuring DNS Server Use 49
Configuring SIP Server Use 49
Configuring LDAP Server Use 50
Figure 2-7 SCOPIA iVIEW 51
Configuring ISDN Connectivity 52
Figure 2-10 Basic Call 53
Figure 2-11 Advanced Call 53
Step 8 Press Save 54
Configuring Call Properties 55
Configuring IP Settings 56
Configuring Video Quality 57
Securing Calls 58
Maintenance Tasks 59
Figure 3-2 Web Interface 61
Step 2 Select Remote access 62
Upgrading the Software 63
Troubleshooting 69
Activating Recovery Mode 70
Figure 4-4 Initial Screen 71
XT1000_V1_0_5.exe) 73
12 Mbps License 75
Call Performance 76
Graphics 76
IP Address 77
Monitor and Power On 77
PC Presentation 78
Remote Control Unit 78
Video and Camera 78

Comentarios a estos manuales

Sin comentarios

RADVision SCOPIA 1000 Guía de usuario Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores RADVision SCOPIA 1000