RADVision Scopia Elite 5100 Series Guía de instalación descargar pdf (Pagina 29)

Performing Initial Configuration of the SCOPIA Elite MCU | 25

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.5

Procedure

Step 1 Connect the network cable of the management subnet to the left ethernet port only, and activate

the unit.

Figure 4-8 Two ethernet connectors of the SCOPIA Elite MCU

Note: Do not connect the media subnet cable until the MCU has been reset at the end of this

procedure.

Step 2 Access the MCU in a web browser and login.

Step 3 Select the Configuration tab.

Step 4 Select the Advanced IP (Dual-NIC) Configuration check box to expand that section of the page.

Figure 4-9 Dual-NIC configuration for management and media subnets

Step 5 Under Management Interface, enter the IP information for the management subnet:

a. Enter the MCU’s IP address on the management subnet in the Primary IP address field.

1 2 ... 24 25 26 27 28 29 30 31

Sin comentarios

RADVision Scopia Elite 5100 Series Guía de instalación Pagina 29