RADVision SCOPIA 400 Guía de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 208
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
26 SCOPIA 400/1000 Gateway User Guide
Mounting the SCOPIA 400 Chassis in a 19-inch Rack
MOUNTING THE
SCOPIA 400
C
HASSIS IN A
19-
INCH RACK
You can optionally mount the SCOPIA 400 chassis in a standard 19-inch rack.
Two mounting brackets and a set of screws are included in the SCOPIA 400
chassis shipping box.
Procedure
1 Disconnect all cables including the power cables.
2 Place the SCOPIA 400 chassis right-side up on a hard flat
surface, with the front panel facing you.
3 Position a mounting bracket over the mounting holes on each
side of the SCOPIA 400 chassis, as shown in Figure 2-4.
4 Pass the screws through the brackets and tighten them into the
screw holes on each side of the SCOPIA 400 chassis using a
suitable screwdriver.
Figure 2-4 Fitting a Bracket for Rack Mounting
5
Insert the SCOPIA 400 chassis into the 19-inch rack.
6 Fasten the brackets to the side rails of the rack.
7 Make sure that the air vents at the sides of the SCOPIA 400
chassis are not blocked.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 207 208

Comentarios a estos manuales

Sin comentarios