RADVision Scopia XT5000 Series Guía de instalación descargar pdf (Pagina 45)

Configuring Remote Upgrade Settings

In order to upgrade your SCOPIA XT Series from the web interface, remote upgrade must be

enabled. This procedure describes how to:

•

Enable/disable remote upgrades (it is enabled by default)

•

Limit access to specific computers in the network. By default, all computers in the

network can perform remote upgrades.

Before you begin

•

Ensure that remote management is enabled. By default, it is. If you changed this

configuration, make sure that you enable it, as described in “Configuring Remote

Management on the SCOPIA XT Series” on page 38.

•

Verify the IP address and the subnet mask associated with this IP address. Contact your

network administrator for details if necessary.

Procedure

Step 1

Access the remote download settings, as follows:

•

From the SCOPIA XT Series web interface, select Administrator Settings > Utilities >

Remote Access > Download.

•

From the endpoint's Main menu, select Configure > Advanced > Utilities > Remote

Access > Download.

Figure 5-3 Enabling remote access to the SCOPIA XT Series

Step 2

Set the fields as described in Table 5-2 on page 41.

RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 40

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 112 113

Sin comentarios

RADVision Scopia XT5000 Series Guía de instalación Pagina 45