RADVision Scopia XT5000 Series Guía de instalación descargar pdf (Pagina 118)

Figure 69: Configuring NAT traversal settings from the web interface

2. Set the fields as described in Table 29: Configuring NAT-related settings on page 118.

Table 29: Configuring NAT-related settings

Field Name Description

NAT Traversal Set to Yes to allow the system to be located behind a firewall/NAT.

Set to No if the system is not located behind a firewall/NAT, but has a

public IP address.

NAT Discovery Manual method of setting the system’s firewall/NAT public IP

address. Enter the Public IP address for that setting.

HTTP discovery - This method uses a Radvision HTTP server to

discover the presence of a firewall/NAT and its public IP address

(requires the endpoint to have internet access).

STUN discovery - This method uses a public STUN server to

discover the presence of a firewall/NAT and its public IP address.

This is the suggested method.

Public IP Address Firewall public IP address. The field is enabled if NAT Traversal is

set to Yes.

Refresh Time (sec) Sets the opening time, in seconds of the pinhole inside the firewall.

Also used by H.460 as TTL (Time To Live) of registration requests.

Important:

Set the ports in accordance with the settings detailed in Configuring the TCP or UDP Port

Range on the Scopia XT Endpoint for IP Office on page 23.

3. From the web interface only, select Save.

Installation Guide for Scopia XT5000 Endpoint with Embedded

Server for IP Office Version 3.2

Initial Configuration | 118

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 158 159

Sin comentarios

RADVision Scopia XT5000 Series Guía de instalación Pagina 118