RADVision Scopia XT5000 Series Guía de instalación descargar pdf (Pagina 19)

With the gateway approach less communication lines are needed. As all gateways do not connect at the

same time and not all calls are ISDN, many more endpoints can share the same ISDN connection and

gateway.

Before you begin

Enable Peer-to-Peer mode in the Scopia Gateway for ISDN. For more information, see the Scopia

Gateway documentation.

Procedure

1. Access the XT Endpoint web interface, as described in Accessing XT Endpoint Web

Interface on page 55.

2. Select Administrator Settings > Protocols > ISDN.

3. Configure the IDSN settings as described below:

Figure 5: Enabling ISDN connectivity

Table 5: Supporting ISDN Connectivity

Field Description

Enable Select Yes to allow this Scopia XT Endpoint for IP Office to

quickly dial ISDN endpoints via the Scopia Gateway for

ISDN.

Gateway IP Address Enter the IP address of the Scopia Gateway for ISDN used

by your organization.

4. Select Save.

Implementing External API Control

You can control the XT Codec Unit using the Scopia XT Endpoint for IP Office API (requires integration

with AMX, Creston, or Extron control devices). Contact Radvision customer support to receive the

Installation Guide for Scopia XT5000 Endpoint with Embedded

Server for IP Office Version 3.2

Planning the Topology of the Scopia XT Endpoint for IP Office

Deployment | 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 158 159

Sin comentarios

RADVision Scopia XT5000 Series Guía de instalación Pagina 19